Request Help
2
Posts
1
Users
0
Likes
534
Views
Topic starter
I'm getting a warning when I calculate my results, "not enough pressure" for every node even though the pressure seems sufficient through the system. What could the problem be?
Posted : 23/06/2023 10:08 pm
Topic starter
This may be caused by the PRVs! By default, when you add a PRV to your system, the target pressure is set at 0.
Click on your PRV in Design mode, and change the settings to the desired target pressure to allow sufficient pressure to reach the fixtures/nodes.
If this doesn't solve your problem, post it below and we'll find a solution!
Posted : 23/06/2023 10:17 pm
